I want to use a rope to make a bracelet and compile the ring in, I am a novice, simple, there are pictures, or videos
3 thoughts on “How to compile the ring into the bracelet”
Leave a Comment
You must be logged in to post a comment.
Shopping Cart
1. Preparation tools: red rope, scissors, ruler, ring, lighter, as shown in the figure below.
2, first take two red ropes of the same length and short, and go into the ring according to the method in the figure. The length of the wire rope can be determined according to the size of your wrist.
3. After completing Figure 4, the ring is compiled into the bracelet as shown in Figure 5. Next, you only need to make the red rope into a bracelet that can be worn.
4. Put the red rope on one side into a circle, pass through the red rope on the other side, and then tighten the red rope that pass through the circle, then pass through the red rope through the bracelet body bundled by the brands of the binding body. Tightened a circle.
5. Finally adjust the excess rope, which can be worn in your own wrist, and then burn the line head to fire to prevent the tip to prevent the silk.
The easiest bracelet compilation method: 1. First twist the rope into twisted, and make several snake knots and buttons in the middle. ), Twist another section of the symmetry of the twist rope to the front, and finally compile a button to end (burn the two thread heads with a lighter together to pay attention to the flames and do not touch the line. Use the heat of the fire to burn the line. To the middle)
The easiest bracelet compilation method: 1. First twist the rope into twisted, and make several snake knots and buttons in the middle. ), Twist another section of the symmetry of the twist rope to the front, and finally compile a button to end (burn the two thread heads with a lighter together to pay attention to the flames and do not touch the line. Use the heat of the fire to burn the line. To the middle)