Gantry crane brake device, when not in use, open the brake, MG80/10m gantry crane in this state. When strong winds blow, it can resist a certain amount of wind. Gantry crane controller should maintain its braking function from time to time, shall not lose the effect. Equipped with anti-skid pad, when the weather is bad, the anti-skid pad will be placed near the wheel, to avoid rocking back and forth, violating the track. Necessary windproof accessories: clip, short bar, wire rope, etc.
The clasp is attached to the ground and the lever acts as support to prevent the gantry from falling down. Electric hoist, motor and other important parts should be covered to avoid rain, so that the equipment is in a state of oxidation and corrosion, and gradually affect the function of the gantry crane. Open the gantry crane rail clamp, and then turn off the power, blocking all circuits. When the gantry crane meets a typhoon, the shaking will be more violent. At this point, the stability is low. Other methods should be used to enhance its stability. Secure the four directions with wire rope. After tightening, the rail clamp was opened to plug the power supply, and several heavy stone piers were placed around the wheel. Through these two steps, the gantry crane can avoid being blown down in strong winds.